Betekenis van:
absolute temperature

Voorbeeldzinnen

1. T absolute temperature at venturi inlet, K
2. Absolute temperature of the intake air
3. T absolute temperature at venturi inlet (K)
4. air pressure of 100 kPa absolute and temperature of 15 °C.
5. Q flow of air in standard m3/min (100 kPa absolute and temperature of 15 °C)
6. T is the absolute temperature in Kelvins (K) of the air drawn in by the engine.
7. The flow test must be carried out at an upstream air pressure of 200 kPa absolute, and at temperature of 15 °C.
8. The air flow-rate is then converted to pump flow (V0) in m3/rev at absolute pump inlet temperature and pressure.
9. The air flow rate must then be converted to pump flow (V0) in m3/rev at absolute pump inlet temperature and pressure as follows:
10. The test vehicle shall be exposed to one cycle of ambient temperature according to the profile specified in Appendix 2 to this annex with a maximum deviation of ±2 K at any time. The average temperature deviation from the profile, calculated using the absolute value of each measured deviation, shall not exceed ±1 K. Ambient temperature shall be measured at least every minute.
11. The calculated flow-rate (given in m3/min. at pump inlet, absolute pressure and temperature) can then be plotted versus a correlation function which is the value of a specific combination of pump parameters.
12. The animal by-products are heated to a core temperature of at least 180 °C for at least 40 minutes without interruption at a pressure (absolute) of at least 12 bar, heated by indirect steam application to the biolytic reactor;
13. The calculated flow rate (in m3/min at pump inlet, absolute pressure and temperature) must be plotted versus a correlation function which is the value of a specific combination of pump parameters.
14. The test vehicle shall be exposed to one cycle of ambient temperature according to the profile specified in Appendix 2 to this annex with a maximum deviation of ±2 K at any time. The average temperature deviation from the profile, calculated using the absolute value of each measured deviation, shall not exceed ±1 K. Ambient temperature shall be measured at least every minute. Temperature cycling begins when time Tstart = 0, as specified in paragraph 5.7.6. below.
15. The absolute temperature (Ta) of the engine air at the inlet to the engine expressed in Kelvin, and the dry atmospheric pressure (ps), expressed in kPa shall be measured and the parameter fa shall be determined according to the following provisions. In multi-cylinder engines having distinct groups of intake manifolds, for example, in a “V” engine configuration, the average temperature of the distinct groups shall be taken.