Betekenis van:
air bag
air bag
Zelfstandig naamwoord
- a safety restraint in an automobile; the bag inflates on collision and prevents the driver or passenger from being thrown forward
Hyperoniemen
Voorbeeldzinnen
- Ambient-air sampling bag (sample taken during test)
- When using a dilute exhaust gas analysis system, the relevant background concentrations shall be determined by sampling dilution air into a sampling bag over the complete test sequence.
- A bag sampling system may be used to collect a proportional sample of the air withdrawn from and admitted to the enclosure.
- Bags (B) for collecting samples of the diluted exhaust gas and the dilution air during the tests; they shall be of sufficient capacity not to impede the sample flow; the bag material shall be such as to affect neither the measurements themselves nor the chemical composition of the gas samples (for instance: laminated polyethylene/polyamide films, or fluorinated poly-hydrocarbons);
- those specially designed for a specific commercial use consisting of the actuation or operation by explosive means of other equipment or devices the function of which is not the creation of explosions (e.g. car air-bag inflators, electric-surge arresters or fire sprinkler actuators).
- Two potential means of accommodating the internal volume changes are movable panel(s), or a bellows design, in which an impermeable bag or bags inside the enclosure expand(s) and contracts(s) in response to internal pressure changes by exchanging air from outside the enclosure.
- CO, CO2, NMHC and CH4 must be determined by integration or by analysing the concentrations in the sample bag, collected over the cycle. The concentrations of the gaseous pollutants in the dilution air must be determined by integration or by collecting into the background bag. All other values must be recorded with a minimum of one measurement per second (1 Hz). 3.8.3. Particulate sampling (if applicable) At the start of the engine or test sequence, if the cycle is started directly from the preconditioning, the particulate sampling system must be switched from by-pass to collecting particulates. If no flow compensation is used, the sample pump(s) must be adjusted so that the flow rate through the particulate sample probe or transfer tube is maintained at a value within ± 5 per cent of the set flow rate.