Betekenis van:
computer memory

Voorbeeldzinnen

1. My first computer had only 128 kilobytes of memory!
2. Personal Computer Memory Card International Association (PCMCIA) adaptors and interfaces
3. the computer shall be designed so that the memory is easily accessible and can be changed,
4. Manufacturers using programmable computer code systems (e.g. Electrical Erasable Programmable Read-Only Memory, EEPROM) shall deter unauthorised reprogramming.
5. Manufacturers using programmable computer code systems (e.g. electrical erasable programmable read-only memory, EEPROM) must deter unauthorised reprogramming.
6. Upon determination of the first malfunction of any component or system, ‘freeze-frame’ engine conditions present at the time shall be stored in computer memory.
7. Record basic information about the computer’s configuration — computer type, operating system name and version, processor type and speed, and total and available physical memory, etc.
8. ‘OBD’ means an on-board diagnostic system for emission control, which has the capability of detecting the occurrence of a malfunction and of identifying the likely area of malfunction by means of fault codes stored in computer memory;
9. If the storage in the computer memory of a non-erasable fault code is required for complying with the requirements of paragraph 5.5., the following three conditions shall be met by the end of demonstration sequence:
10. This adder applies to imaging products that rely on an external computer for significant resources, such as memory and data processing, to perform basic functions commonly performed by imaging products independently, such as page rendering.
11. If the storage in the computer memory of a non-erasable fault code is required for complying with the requirements of section 6.5, the following three conditions shall be met by the end of demonstration sequence:
12. ‘OBD’ means an on-board diagnostic system for emission control which shall have the capability of identifying the likely area of malfunction by means of fault codes stored in computer memory.
13. For all emission control systems for which specific on-board evaluation tests are conducted, separate status codes, or readiness codes, must be stored in computer memory to identify correctly functioning emission control systems and those emission control systems which require further vehicle operation to complete a proper diagnostic evaluation.
14. DTC and the applicable information (inclusive the associated freeze frame) shall not be erased by the OBD system itself from the computer memory until that DTC has been in the previously active status for at least 40 warm-up cycles or 200 engine operating hours, whichever occurs first.
15. “net power” means the power in EC kW obtained on the test bench at the end of the crankshaft, or its equivalent, measured in accordance with the EC method of measuring power as set out in Commission Directive 80/1269/EEC; “OBD” means an on-board diagnostic system for emission control, which has the capability of detecting the occurrence of a malfunction and of identifying the likely area of malfunction by means of fault codes stored in computer memory;