Betekenis van:
inaccuracy

inaccuracy
Zelfstandig naamwoord
  • iets dat niet waar is; het niet waar zijn
  • the quality of being inaccurate and having errors

Hyperoniemen

Hyponiemen


Voorbeeldzinnen

  1. There are a number of methodological problems here, not to mention the inaccuracy of some of the results.
  2. "Accuracy" (2 6), usually measured in terms of inaccuracy, means the maximum deviation, positive or negative, of an indicated value from an accepted standard or true value.
  3. In the case of infringements relating to inaccuracy and/or conceptual compliance, the seriousness of the infringement shall depend on the size of the error.
  4. N.B.:Category references are given in brackets after the defined term. "Accuracy" (2 6), usually measured in terms of inaccuracy, means the maximum deviation, positive or negative, of an indicated value from an accepted standard or true value.
  5. Parliament shall reserve the right, where acceptance or termination of office appears to be based on material inaccuracy or vitiated consent, to declare the appointment under consideration to be invalid or refuse to establish the vacancy.
  6. N.B.: Category references are given in brackets after the defined term. "Accuracy" (2 6), usually measured in terms of inaccuracy, means the maximum deviation, positive or negative, of an indicated value from an accepted standard or true value.
  7. If the accuracy of an item of personal data is contested by the data subject and its accuracy or inaccuracy cannot be ascertained, referencing of that item of data may take place.
  8. The Commission considers, therefore, that SIDE's additional comments, on the inaccuracy of the accounting data transmitted by the French authorities when the proceedings were initiated in 1996, do not call into question the Commission's assessment of the relevance of the accounting data justifying the compensation for the extra costs generated by small orders.
  9. "Accuracy" (2 6), usually measured in terms of inaccuracy, means the maximum deviation, positive or negative, of an indicated value from an accepted standard or true value. "Active flight control systems" (7) are systems that function to prevent undesirable "aircraft" and missile motions or structural loads by autonomously processing outputs from multiple sensors and then providing necessary preventive commands to effect automatic control.
  10. Where a body of one Member State has supplied personal data under this Decision, the receiving body of the other Member State cannot use the inaccuracy of the data supplied as grounds to evade its liability vis-à-vis the injured party under national law.
  11. Definitions of terms between "double quotation marks" are as follows: N.B.:Category references are given in brackets after the defined term. "Accuracy" (2 6), usually measured in terms of inaccuracy, means the maximum deviation, positive or negative, of an indicated value from an accepted standard or true value.
  12. Therefore, albeit the findings are sufficiently reliable to justify a modification in the level of the anti-dumping duties, on its own initiative or at the request of interested parties the Community institutions might carry out a review of the modified antidumping duties should available information sources point out to a change or otherwise inaccuracy of the findings verified in the third country.
  13. Hence, the right of withdrawal is linked to the timing of the new factor, mistake or inaccuracy that gives rise to a supplement, and assumes that that triggering event has occurred while the offer was open and before delivery of the securities.
  14. "Accuracy" (2 6), usually measured in terms of inaccuracy, means the maximum deviation, positive or negative, of an indicated value from an accepted standard or true value. "Active flight control systems" (7) are systems that function to prevent undesirable "aircraft" and missile motions or structural loads by autonomously processing outputs from multiple sensors and then providing necessary preventive commands to effect automatic control.
  15. On the other hand, the right to withdraw an acceptance should be applicable only where the prospectus relates to an offer of securities to the public and the new factor, mistake or inaccuracy arose before the final closing of the offer and the delivery of the securities.