Betekenis van:
reference grid
reference grid
Zelfstandig naamwoord
- a pattern of horizontal and vertical lines that provide coordinates for locating points on an image or a map
Hyperoniemen
Voorbeeldzinnen
- RELATIONSHIP BETWEEN REFERENCE GRID AND VEHICLE’S PRIMARY REFERENCE MARKS
- Part of the county of Suffolk contained within a circle of radius 10 kilometres, centred on grid reference TM4009079918 [1]
- In addition correction factors for avoided grid losses should be applied to these reference values to take account of the energy savings obtained when grid use is limited due to decentralised production.
- The three-dimensional reference grid for the coordinates is as defined in point 2.3 of Annex I to Directive 77/649/EEC as amended.
- Correction factors for avoided grid losses for the application of the harmonised efficiency reference values for separate production of electricity (referred to in Article 2(2))
- Area comprising that part of the counties of Suffolk and Norfolk contained within a circle of radius 10 kilometres, centred on grid reference TM 06178 76666 [1].
- Area comprising that part of the counties of Oxfordshire and Warwickshire on the boundary of and within a circle of radius 3,215 kilometres, centred on grid reference SP36412 42196 [1].
- Area comprising that part of the counties of Oxfordshire and Warwickshire on the boundary of and within a circle of radius 10,215 kilometres, centred on grid reference SP36412 42196 [2].
- The position of the ocular points in relation to the R point shall be adjusted as indicated in the table below by X coordinates from the three-dimensional reference grid.
- The geographical unit of reference for the purposes of bluetongue monitoring and surveillance shall be defined by a grid of around 45 × 45 km (approximately 2000 km2) unless specific environmental conditions justify a different size.
- After the grid loss correction the resulting efficiency reference value for the separate production of electricity in this cogeneration unit would be (based on the weighted mean of the factors in this Annex):
- In order to provide for minor changes in suspension height, etc., it will be necessary to have available a means of bringing the reference marks to the correct coordinate positions relative to the design attitude before further measurements are taken. In addition, it must be possible to make minor lateral and/or longitudinal adjustments of the vehicle’s position so as to place it accurately in relation to the reference grid.