Betekenis van:
screen test

Voorbeeldzinnen

1. Screen refresh rate (during test) (Hz)
2. Before the test the screen must be heated to 308 K ± 5 K (35 °C ± 5°C).
3. Before the test the screen must be heated to 308 K ± 5 K (35 °C ± 5°C). The firebricks may be wetted in order to guarantee the same test conditions for each successive test.
4. The test screen must be sufficiently wide to allow examination of the ‘cut-off’ over a range of at least 5° on either side of the line vv.
5. Each applied position is realized on the test goniometer with respect to a line joining the centre of the light source and point HV on a aiming screen.
6. Each applied position is realized on the test goniometer with respect to a line joining the centre of reference and point HV on an aiming screen.
7. During phase C of the test, the pan must be covered by a screen placed 3 cm ± 1 cm above the fuel level.
8. Measurements of peak luminance shall be made with a luminance meter, detecting that portion of the screen exhibiting a full (100 %) white image, which is part of a ‘full screen test’ test pattern that does not exceed the average picture level (APL) point where any power limiting occurs in the display luminance drive system.
9. Methods with a performance equivalent to EpiDerm™ (validated reference method 2) are only recommended as a screen test method, or as part of a sequential testing strategy in a weight of evidence approach, for classifying GHS category 2 irritant substances.
10. During phase C of the test, the pan must be covered by a screen placed 3 cm ± 1 cm above the fuel level. The screen must be made of a refractory material, as prescribed in Appendix 2. There must be no gap between the bricks and they must be supported over the fuel pan in such a manner that the holes in the bricks are not obstructed.
11. For CRT monitors, the technician shall initiate the AT01P (Alignment Target 01 Positive Mode) pattern (VESA FPDM Standard 2.0, A112-2F, AT01P) for screen size and use it to set the computer monitor to the manufacturer’s recommended image size, which is typically slightly smaller than maximum viewable screen size. Then, test pattern (VESA FPDM Standard 2.0, A112-2F, SET01K) shall be displayed that provides eight shades of gray from full black (0 volt) to full white (0,7 volt) [3].
12. "Proof Test": on-line or off-line production screen testing that dynamically applies a prescribed tensile stress over a 0,5 to 3 m length of fibre at a running rate of 2 to 5 m/s while passing between capstans approximately 150 mm in diameter.
13. Proof Test: on-line or off-line production screen testing that dynamically applies a prescribed tensile stress over a 0,5 to 3 m length of fibre at a running rate of 2 to 5 m/s while passing between capstans approximately 150 mm in diameter. The ambient temperature is a nominal 293 K (20 °C) and relative humidity 40 %.
14. Proof Test: on-line or off-line production screen testing that dynamically applies a prescribed tensile stress over a 0,5 to 3 m length of fibre at a running rate of 2 to 5 m/s while passing between capstans approximately 150 mm in diameter. The ambient temperature is a nominal 293 K (20 °C) and relative humidity 40 %.
15. "Proof Test": on-line or off-line production screen testing that dynamically applies a prescribed tensile stress over a 0,5 to 3 m length of fibre at a running rate of 2 to 5 m/s while passing between capstans approximately 150 mm in diameter. The ambient temperature is a nominal 293 K (20 °C) and relative humidity 40 %.