Betekenis van:
tank top

tank top
Zelfstandig naamwoord
    • a tight-fitting sleeveless shirt with wide shoulder straps and low neck and no front opening; often worn over a shirt or blouse

    Hyperoniemen


    Voorbeeldzinnen

    1. The top cover of a gasoline tank is foating when they are filling.
    2. .1.6 Decks shall be sequentially numbered, starting with ‘1’ at the tank top or lowest deck.
    3. .1.6 Decks shall be sequentially numbered, starting with “1” at the tank top or lowest deck.
    4. NEW CLASS B, C AND D AND EXISTING CLASS B SHIPS: .2 Other means of ascertaining the amount of oil fuel contained in any oil fuel tank may be permitted if such means, like the means provided in subparagraph .2.6.1.1, do not require penetration below the top of the tank, and providing their failure or overfilling of the tanks will not permit release of fuel.
    5. .1 40 % of the gross volume of the largest machinery space so protected, the volume to exclude that part of the casing above the level at which the horizontal area of the casing is 40 % or less of the horizontal area of the space concerned taken midway between the tank top and the lowest part of the casing; or
    6. In view of the serious loss of stability which could arise due to large quantities of water accumulating on the deck or tank top consequent on the operation of the fixed pressure water-spraying system, the Administration of the flag State may require pumping and drainage facilities to be provided additional to the requirements of Regulation II-1/C/3.
    7. .5 Tanks which are intended to hold liquids, and which form part of the subdivision of the ship, shall be tested for tightness with water to a head up to the deepest subdivision load line or to a head corresponding to two thirds of the depth from the top of keel to the margin line in way of the tanks, whichever is the greater, provided that in no case shall the test head be less than 0,9 metres above the top of the tank; if testing by water is impracticable, air leak testing while the tanks are subjected to an air pressure of not more than 0,14 bar may be accepted.