Betekenis van:
disable

Voorbeeldzinnen

1. I wish I could figure out how to disable comments on my blog.
2. disable all other control or operating modes,
3. Manufacturers may request approval to utilize a voltage threshold higher than this value to disable system monitoring.
4. High pulsed power or high average power radio frequency beam transmitters which produce fields sufficiently intense to disable electronic circuitry at a distant target.
5. The manufacturer may request approval to temporarily disable affected monitoring systems in vehicles equipped with a PTO unit, under the condition where that PTO unit is temporarily active.
6. Manufacturers may request approval to disable monitoring systems that are affected by low fuel level or running out of fuel (e.g. diagnosis of a malfunction of the fuelling system or misfiring).
7. The manufacturer may request approval to disable the affected OBD monitoring systems during the forced regeneration of an emission control system downstream of the engine (e.g. a particulate filter).
8. a first part, which may be brief, provided that it exhibits evidence concerning the relationships between monitors, sensors/actuators, and operating conditions (i.e. describes all enable conditions for monitors to run and disable conditions that cause monitors not to run).
9. be shipped with Wake On LAN (WOL) enabled from the Sleep mode when operating on AC power (i.e. notebooks may automatically disable WOL when disconnected from the mains); or
10. Table 2 in appendix 5 shows the other OBD information which must be included if used by the emission or OBD system to enable or disable any OBD monitors.
11. For monitoring systems affected by low vehicle battery or system voltages, manufacturers may request approval to disable monitoring systems when the battery or system voltage is below 90 per cent of the nominal voltage (or 11.0 Volts for a 12 Volt battery, 22.0 Volts for a 24 volt battery).
12. Manufacturers may request approval to disable OBD system monitors at ambient engine start temperatures below 266 K (- 7 degrees Celsius or 20 degrees Fahrenheit) or above 308 K (35 degrees Celsius or 95 degrees Fahrenheit), or at elevations above 2500 meters (8202 feet) above sea level.
13. disable, in the case of after-market fitting, or vehicle equipped with diesel engine, at least two separate vehicle circuits that are needed for vehicle operation under its own power (e.g. starter motor, ignition, fuel supply, pneumatically released spring brakes, etc.);
14. The manufacturer may request approval to disable OBD system monitors during the operation of an AECS, including MECS, under conditions not already covered in paragraph 5.2. if the monitoring capability of a monitor is affected by the operation of an AECS.
15. The manufacturer shall demonstrate that monitoring above the manufacturer-defined voltage would be unreliable and that either the electrical charging system/alternator warning light is illuminated (or voltage gauge is in the ‘red zone’) or the OBD system monitors the battery or system voltage and will detect a malfunction at the voltage used to disable other monitors.