Betekenis van:
hand brake

Voorbeeldzinnen

1. Hand operated brake control valve
2. Hand-operated brake control valve
3. The sensor on the hand brake can be deactivated by a partially engaged hand brake.
4. The accelerator and brake controls for movement of machinery running on rails must be hand-operated.
5. Pedal/hand lever condition and travel of the brake operating device
6. Control and Performance of the parking brake shall be such that with 500 N force applied to the end of a brake lever or tangentially to a hand wheel rim, the parking brake is fully applied. 500 N input force
7. Control and Performance of the parking brake shall be such that with 500 N force applied to the end of a brake lever or tangentially to a hand wheel rim, the parking brake is fully applied.
8. The sensor on the hand brake can be deactivated by a partially engaged hand brake. (This is an example of misuse which is reasonably foreseeable and should, therefore, have been designed out, or clear warnings provided.)
9. The contra ram group of wagons shall be protected against rolling by hand-brake or braking skids.
10. Handles or hand wheels shall be used to operate the parking brake, but only hand wheels may be used for brakes operated from the ground.
11. There are different types of hand pallet trucks and their essential parts depending mainly on the lift capacity, length of the forks, type of steel used for the chassis, type of hydraulics, type of wheels and existence of a brake.
12. The driver's door shall be accepted as the emergency door for the occupants of those seats, provided that the driver's seat, the steering wheel, the engine housing, the gear lever, the hand brake control, etc., do not constitute too great an obstruction.
13. The applied force in loaded state shall be 3000 kN ±10 %. The contra ram group of wagons shall be protected against rolling by hand-brake or braking skids. Impact in unloaded state The speed of the ram wagon shall be 12 km/h. The tested wagon shall be unbraked.
14. The hand-brake control, if mounted on or under the instrument panel, shall be so placed that, when it is in the position of rest there is no possibility of the occupants of the vehicle striking against it in the event of a frontal impact.
15. the hand brake control when in the released position and the gear lever when in any forward gear position, have, except when placed in the zones defined in paragraphs 2.3.1 and 2.3.2 and in the zones below the horizontal plane passing through the ‘H’ point of the front seats, a surface area of not less than 6 cm2 measured at a cross-section normal to the longitudinal horizontal direction up to a distance of 6,5 mm from the part projecting furthest, the radius of curvature being not less than 3,2 mm. (see Annex X, explanatory notes, paragraph 5.3.2.3)