Betekenis van:
slide by

to slide by
Werkwoord
  • voorbijgaan, verglijden, verstrijken, vervlieden, omgaan
  • pass by

Synoniemen

Hyperoniemen

Hyponiemen

Werkwoord


Voorbeeldzinnen

  1. Air-dry the slides (or on slide dryer at 37 °C) and fix them by flaming.
  2. S (ZP) thickness of fat (including rind), measured by a slide rule in the point where the musculus gluteus medius (m.g.m.) is the most convex (mm),
  3. Naturally infected tissue (maintained by lyophilization or freezing at –16 to –24 °C) should be used where possible as a similar control on the same slide.
  4. one garment such as an anorak, windcheater, wind-jacket or similar article, closed by a slide fastener (zipper), possibly with a waistcoat in addition, and
  5. If the 3-D H machine does not tend to slide rearward, use the following procedure. Slide the 3-D H machine rearwards by applying a horizontal rearward load to the T-bar until the seat pan contacts the seat-back (see figure 2 of Appendix 1 to this Annex).
  6. Recently, new information has become available showing that pentaBDE is used in specific fabrics for aircraft evacuation slides and slide-rafts and cannot be replaced by suitable alternatives due to the extensive safety testing and regulatory requirements.
  7. Fix the bacterial cells to the slide either by heating (15 minutes at 60 °C), flaming, with 95 % ethanol or according to specific instructions from the suppliers of the antibodies.
  8. Wheel slide protection (WSP) is a system designed to make the best use of available adhesion by a controlled reduction and restoration of the brake force to prevent wheel sets from locking and uncontrolled sliding, thereby optimising stopping distance.
  9. By using a small spoon or a spatula one half of the decanted impurities is transferred to a small Petri dish or a microscopic slide for microscopic identification of a possible content of animal constituents (meat fibres, feathers, bone fragments, …).
  10. Slide the 3-D H machine rearwards by applying a horizontal rearward load to the T-bar until the seat pan contacts the seat-back (see figure 2 of appendix 1 to this annex).
  11. Wheel slide protection (WSP) is a system designed to make the best use of available adhesion by a controlled reduction and restoration of the brake force to prevent wheelsets from locking and uncontrolled sliding, thereby optimising stopping distance.
  12. Fix the bacterial cells to the slide either by heating (15 minutes at 60 °C), flaming, with 95 % ethanol or according to specific instructions from the suppliers of the antibodies. If necessary, fixed slides may then be stored frozen in a desiccated box for as little time as necessary (up to a maximum of three months) prior to further testing.
  13. For the purposes of this Directive, “part” shall mean any element or replacement element specifically designed for a firearm and essential to its operation, including a barrel, frame or receiver, slide or cylinder, bolt or breech block, and any device designed or adapted to diminish the sound caused by firing a firearm.
  14. The other elements of the vehicle’s equipment not covered by the above paragraph, such as seat slide rails, devices for regulating the horizontal or vertical part of the seat, devices for rolling up safety belts, etc. are not subject to any regulation if they are situated below a horizontal line passing through the ‘H’ point of each seat, even though the occupant is likely to come into contact with such items.