Betekenis van:
slip by

Werkwoord

Voorbeeldzinnen

1. Don't let this chance slip by.
2. For flights which do not exceed 60 minutes duration, which take off and land at the same aerodrome, and which remain within 50 nm of that aerodrome, the instruments prescribed in subparagraphs (f), (g) and (h) above, and subparagraphs (k)(4), (k)(5) and (k)(6) below, may all be replaced by either a turn and slip indicator, or a turn co-ordinator incorporating a slip indicator, or both an attitude indicator and a slip indicator.
3. Particulate influx over time will cause the pump slip to decrease, as reflected by lower values for m. Therefore, calibration must be performed at pump start-up, after major maintenance, and if the total system verification (paragraph 2.4) indicates a change of the slip rate.
4. Particulate influx over time will cause the pump slip to decrease, as reflected by lower values for m. Therefore, calibration shall be performed at pump start-up, after major maintenance, and if the total system verification (section 3.5) indicates a change in the slip rate.
5. The starting noise is also dominated by the auxiliaries in addition to the sound of the wheel/rail contact, especially as a function of wheel slip velocity, by the traction components (motor, gear, traction converter and Diesel engines).
6. The requirements of sections 5.3.1, 5.3.2 and 5.3.3 are based on a traditional design of ballasted track with Vignole (flat-bottom) rail on concrete sleepers and fastening providing resistance to longitudinal slip by bearing on the rail foot.
7. Where there are pedals, they must be so designed, constructed and fitted as to allow safe operation by the driver with the minimum risk of incorrect operation. They must have a slip-resistant surface and be easy to clean.
8. The proof referred to in paragraph 1 shall be furnished by submission of the summary payment slip provided for in Article 9, accompanied either by certification of payment by the producer or by a voucher issued by the financial institution that made the payment on the order of the starch manufacturer, certifying that such payment has been made.
9. Inspection slip: document by which the producer certifies that the products delivered meet the requirements of the order and in which he sets out the results of the routine in-plant inspection test, in particular chemical composition and mechanical characteristics performed on products made by the same production process as the supply, but not necessarily on the products delivered.
10. Table A Risk EstimationTable B Grading of RiskNoYesNoYesAdequate warnings andsafeguards?NoNoYesYesobvious hazard?Very HighHighVery HighVery HighHighMediumHighHighMediumLowModerateMediumLowVery LowLowLowVery LowVery lowSERIOUS RISK RAPID ACTION REQUIREDSeverity of Health/Safety DamageOverallGravity ofOutcomeVulnerable peopleNormal adultsSlightSeriousVery SeriousVeryvulnerableVulnerableProbability of Health/SafetyDamageModerate risk Some action requiredLow risk Action unlikelyTable A is used to determine the gravity of the outcome of a hazard, depending on the severity and probability of the possible health/safety damage (see tables in notes)Table B is used to determine the rating of the gravity of risk depending on the type of user and, for normal adults, whether the product has adequate warnings and safeguards and whether the hazard is sufficiently obvious, and to decide whether a serious risk situation exists and rapid action is requiredExample (indicated by the arrows above)A chain saw user has suffered a badly cut hand and it is found that the chain saw has an inadequately designed guard which allowed the user’s hand to slip forward and touch the chain.