Betekenis van:
stabilize

to stabilize
Werkwoord
    • become stable or more stable
    "The economy stabilized"

    Synoniemen

    Hyperoniemen

    Hyponiemen

    to stabilize
    Werkwoord
    • stabiliseren
    • make stable and keep from fluctuating or put into an equilibrium
    "The drug stabilized her blood pressure"
    "stabilize prices"

    Synoniemen

    Hyperoniemen

    Hyponiemen

    to stabilize
    Werkwoord
      • support or hold steady and make steadfast, with or as if with a brace

      Synoniemen

      Hyperoniemen

      Hyponiemen


      Voorbeeldzinnen

      1. The authorities managed to stabilize the currency.
      2. The authorities are striving in vain to stabilize the currency.
      3. Stabilize the chromatograph.
      4. Stabilize the chromatograph. It is recommended that the following conditions are used:
      5. The engine shall be warmed up at maximum power in order to stabilize the engine parameters according to the recommendation of the manufacturer and good engineering practice.
      6. Heat the wine to 80 °C with the heating mantle, distil and collect 45 to 50 ml of the distillate. Stabilize the chromatograph.
      7. In this scenario, average electricity prices start around EUR 22/MWh in 2006, increase slowly to EUR 30/MWh in 2015, then rise more steeply to around EUR 40/MWh in 2018 and stabilize around this amount, with some upward and downward fluctuations, until the end of the reference period in 2025.
      8. “closed recirculation aquaculture facility” means a facility where aquaculture takes place within an enclosed environment on land or on a vessel involving the recirculation of water, and depending on permanent external energy input to stabilize the environment for the aquaculture animals;
      9. However, if this value is more than 1,0 mrad but not more than 1,5 mrad (1,0 mrad < Δ rI ≤ 1,5 mrad), a second test sample shall be tested as described in paragraph 2.1. after being subjected three consecutive times to the cycle as described below, in order to stabilize the position of mechanical parts of the test sample on a base representative of the correct installation on the vehicle:
      10. However, if this value is more than 1,0 mrad but not more than 1,5 mrad (1,0 mrad < ΔrI ≤ 1,5 mrad) a second headlamp shall be tested as described in paragraph 2.1. after being subjected three consecutive times to the cycle as described below, in order to stabilize the position of mechanical parts of the headlamp on a base representative of the correct installation on the vehicle: