Betekenis van:
storage tank

Voorbeeldzinnen

1. in storage tank bottoms,
2. The bindings and fastenings used to secure the storage tank to the vehicle must be able to hold a tank weighing twice that of the storage tank being transported.
3. This section does not apply in the case of monitoring for reagent level in the storage tank where monitoring shall be conducted under all conditions of use.
4. This paragraph does not apply in the case of monitoring for reagent level in the storage tank where monitoring shall be conducted under all conditions of use.
5. when the reagent in the storage tank does not comply with the characteristics declared and recorded in section 2.2.1.13 of Appendix 1 and section 2.2.1.13 of Appendix 3 to Annex II, according to the installed means of assessment.
6. The storage tank shall be permanently connected by piping in such manner that the hydraulic systems can be readily recharged from a position within the steering gear compartment and shall be provided with a contents gauge.
7. .3 a fixed storage tank having sufficient capacity to recharge at least one power actuating system including the reservoir, where the main steering gear is required to be power-operated. The storage tank shall be permanently connected by piping in such manner that the hydraulic systems can be readily recharged from a position within the steering gear compartment and shall be provided with a contents gauge.
8. .5 Every oil fuel pipe, which, if damaged, would allow oil to escape from a storage, settling or daily service tank, having a capacity of 500 litres or above, situated above the double bottom, shall be fitted with a cock or valve directly on the tank capable of being closed from a safe position outside the space concerned in the event of a fire occurring in the space in which such tanks are situated.
9. Content of the national legislation: Exemption from the requirements of 6.7 and 6.8 of the ADR for the carriage by road of nominally empty uncleaned storage tanks (for storage at fixed premises) for the purpose of cleaning, repair, testing or scrapping, provided that (a) as much of the pipe work which was connected to the tank as was reasonably practicable to remove from it has been removed; (b) a suitable pressure relief valve, which shall remain operational during the carriage, is fitted to the tank; and (c) subject to (b) above all openings in the tank and in any pipe work attached thereto have been sealed to prevent the escape of any dangerous goods, in so far as it is reasonably practicable to do so.
10. Prior to the test, the tank must be filled to 50 per cent of its capacity with testing fuel and stored, without being sealed, at an ambient temperature of 313 K ± 2 K (40 °C ± 2 °C) until the weight loss per unit time becomes constant, but for not more than four weeks (preliminary storage time).
11. the ability to choose and size the components in typical installation situations, including determining the typical values of the heat load of different buildings and for hot water production based on energy consumption, determining the capacity of the heat pump on the heat load for hot water production, on the storage mass of the building and on interruptible current supply; determine buffer tank component and its volume and integration of a second heating system.
12. For ships constructed on or after 1 January 2003 the provisions of paragraph 10.2.5 shall also apply to lubricating oil tanks except those of having a capacity less than 500 litres, storage tanks on which valves are closed during the normal operation of the ship or where it is determined that the unintended operation of a quick closing valve on the lubricating oil tank would endanger the safe operation of the main propulsion and essential auxiliary machinery.