Betekenis van:
yaw

to yaw
Werkwoord
    • swerve off course momentarily
    "the ship yawed when the huge waves hit it"

    Hyperoniemen

    to yaw
    Werkwoord
      • deviate erratically from a set course
      "the yawing motion of the ship"

      Hyperoniemen

      Hyponiemen

      to yaw
      Werkwoord
      • gapen
      • be wide open

      Synoniemen

      Hyperoniemen

      yaw
      Zelfstandig naamwoord
        • an erratic deflection from an intended course

        Synoniemen

        Hyperoniemen


        Voorbeeldzinnen

        1. Yaw controls;
        2. yaw controls;
        3. Brig-Gen Zin Yaw
        4. Son of Brig-Gen Zin Yaw, d.o.b.
        5. Daughter of Brig-Gen Zin Yaw, d.o.b.
        6. 45 (A), Yaw Min Gyi Rd, DGNN, Yangon
        7. Rm #7, Bldg 30-A, Yaw Min Gyi Rd. DGNN, Yangon
        8. 462-463 Yaw A Twinn Wun U Pho HlaingSt, HLTAA, Yangon
        9. 462-463, Yaw A-twinn-wun U Pho Hlaing St. HLTAA, Yangon
        10. Primary flight controls — control surface position and/or pilot input (pitch, roll and yaw)
        11. A roll and yaw rate equal to or greater than + 2,62 radian/s (150 deg/s); or
        12. Angular deviation of slide movement (yaw, pitch and roll) less (better) than 2 seconds of arc, TIR over 300 mm of travel;
        13. angular deviation of slide movement (yaw, pitch and roll) less (better) than 2 seconds of arc, TIR over 300 mm of travel.;
        14. Apparatus for measuring the angle and direction of rotation of motor vehicles, consisting of at least one yaw rate sensor in the form of a monocrystalline quartz, whether or not combined with one or more measuring sensors, the whole contained in a housing
        15. Spindle"run-out" and "camming" less (better) than 0,0004 mm TIR; and b. Angular deviation of slide movement (yaw, pitch and roll) less (better) than 2 seconds of arc, TIR over 300 mm of travel. c. Machine tools for grinding, having any of the following characteristics: 1. Having all of the following: a. Positioning accuracy with "all compensations available" equal to or less (better) than 4 μm according to ISO 230/2 (1988) [1] Manufacturers calculating positioning accuracy in accordance with ISO 230/2 (1997) should consult the competent authorities of the Member State in which they are established. or national equivalents along any linear axis; and