Betekenis van:
throttle
to throttle
Werkwoord
- wurgen, kelen, worgen
- kill by squeezing the throat of so as to cut off the air
Synoniemen
Hyperoniemen
Hyponiemen
throttle
Zelfstandig naamwoord
- regelaar v.d. gastoevoer
- a pedal that controls the throttle valve
Synoniemen
Hyperoniemen
throttle
Zelfstandig naamwoord
- pedaal om gastoevoer te regelen
- a pedal that controls the throttle valve
Synoniemen
Hyperoniemen
throttle
Zelfstandig naamwoord
- a valve that regulates the supply of fuel to the engine
Synoniemen
Hyperoniemen
throttle
Zelfstandig naamwoord
- acceleratiepomp, accelerator, gaspedaal, versneller
- a pedal that controls the throttle valve
Synoniemen
Hyperoniemen
Voorbeeldzinnen
- Make and type of the throttle housing: …
- Electro-mechanical throttle plate actuator for automotive engines
- Wide open throttle, and speed feedback < 95 % speed reference
- No load/closed throttle, idle point and speed > reference idle speed
- With the throttle completely open, the bench shall be adjusted so as to obtain the engine speed(s) corresponding to the rated maximum power of the engine.
- The net power test shall consist of a run at full throttle for positive-ignition engines and at fixed full-load fuel injection pump setting for diesel engines, the engine being equipped as specified in table 1.
- This definition provides a dimensionless number that is not engine specific and provides the service technician with an indication of the proportion of engine capacity that is being used (with wide open throttle as 100 per cent);
- This could be checked, for instance, by monitoring engine speed or by allowing a sufficient time to elapse between initial throttle depression and release, which in the case of vehicles M2, M3, N2 or N3 should be at least two seconds.
- This could be checked, for instance, by monitoring engine speed or by allowing a sufficient time to elapse between initial throttle depression and release, which in the case of vehicles of category 1 and 2 of Annex 1, should be at least two seconds.
- This could be checked, for instance, by monitoring engine speed or by allowing a sufficient time to elapse between initial throttle depression and release, which in the case of vehicles of category 1 and 2 of Annex I should be at least two seconds.