Betekenis van:
gear up

Werkwoord

Voorbeeldzinnen

1. Exhaust gas opacity to be measured during free acceleration (no load from idle up to cut-off speed) with gear lever in neutral and clutch engaged.
2. For the purposes of this point, gillnet and entangling net means a gear made up of a single piece of net and held vertically in the water.
3. For the purposes of this point, trammel net means a gear made up of two or more pieces of net hung jointly in parallel on a single headline and held vertically in the water.
4. For the purposes of this point, gillnet and entangling net means a gear made up of a single piece of net and held vertically in the water. It catches living aquatic resources by gilling, entangling or enmeshing.
5. It can only light up if the reverse gear is engaged and if the device which controls the starting or stopping of the engine is in such a position that operation of the engine is possible.
6. For the purposes of this Annex, ‘Trammel net’ means a gear made up of two or more pieces of net hung jointly in parallel on a single headline and held vertically in the water.
7. Member States, whose vessels intend to conduct fishing activities in new bottom fishing areas, or with bottom gear not previously used in the area concerned, shall set up an Exploratory Fishery Protocol using the templates in Annex XVI.
8. It should be noted that the time of two seconds allowed includes the time for changing gear and, if necessary, a certain amount of latitude to catch up with the cycle.
9. In August 2000, MobilCom Multimedia GmbH made a successful bid of EUR 8,4 billion and obtained a UMTS licence from the Federal Government. In 2001 D Plus was merged with Cellway in order to gear up the distribution structure for the UMTS business.
10. They shall be such that the lamp can light up only if the reverse gear is engaged and if the device which controls the starting and stopping of the engine is in such a position that operation of the engine is possible.
11. ‘bottom-set gillnet’ means any net made up of a single piece of net held vertically in the water by floats and weights fixed or capable of being fixed by any means to the bottom of the sea and maintain the gear in place either close to the bottom or floating in the water column;
12. the hand brake control when in the released position and the gear lever when in any forward gear position, have, except when placed in the zones defined in paragraphs 2.3.1 and 2.3.2 and in the zones below the horizontal plane passing through the ‘H’ point of the front seats, a surface area of not less than 6 cm2 measured at a cross-section normal to the longitudinal horizontal direction up to a distance of 6,5 mm from the part projecting furthest, the radius of curvature being not less than 3,2 mm. (see Annex X, explanatory notes, paragraph 5.3.2.3)
13. At the request of a Member State, the Commission, in accordance with the procedure provided in Article 30(2) of Regulation (EC) No 2371/2002, shall allow a derogation from paragraphs 1, 2 and 3, on condition that such derogation is justified by particular geographical constraints, such as the limited size of coastal platforms along the entire coastline of a Member State or the limited extent of trawlable fishing grounds, where the fisheries have no significant impact on the marine environment and affect a limited number of vessels, and provided that those fisheries cannot be undertaken with another gear and are subject to a management plan as referred to in Articles 18 or 19. Member States shall provide up-to-date scientific and technical justifications for such derogation.