Betekenis van:
pass over

Werkwoord

Voorbeeldzinnen

1. Pass the beer over here.
2. The tori line should be set so that streamers pass over baited hooks in the water.
3. The Community industry was only able to pass to its customers a price increase limited to 4 % while its full costs increased by 20 % over the same period.
4. The indicator for the pass-by noise is the A-weighted equivalent continuous sound pressure level LpAeq, Tp measured over the pass-by time at a distance of 7,5 m from centreline of track, 1,2 ± 0,2 m above top of rail.
5. take over the assets of any company not listed in Appendix A, Part I, and pass on the benefit of aid granted to it in the period up to 31 December 2008.
6. However, the allegation that it is difficult to pass on the cost increase is contradicted by the Netherlands’ statement tha t the tax has been passed on so far, and by the fact that over the period for which the data are submitted exports by the Dutch brick sector increased, from EUR 189 million in 2001 to EUR 225 million in 2007.
7. the actual handing over of goods pursuant to a contract for the hire of goods for a certain period, or for the sale of goods on deferred terms, which provides that in the normal course of events ownership is to pass at the latest upon payment of the final instalment;
8. Indeed, in the IP the average prices of feedstock used by the Community industry to produce biodiesel, were 25 % higher than in 2006. The Community industry was only able to pass to its customers a price increase limited to 4 % while its full costs increased by 20 % over the same period.
9. where the cables supply equipment located within high fire risk areas, the cable runs within such areas must avoid routes which pass over or near the top of diesel engines and oil-fired equipment, or near to hot surfaces e.g. diesel engine exhaust systems. Where there is no alternative route, cables must be protected from heat and fire damage. Such fire protection could be in the form of a steel plate or trunk;
10. CO, CO2, NMHC and CH4 must be determined by integration or by analysing the concentrations in the sample bag, collected over the cycle. The concentrations of the gaseous pollutants in the dilution air must be determined by integration or by collecting into the background bag. All other values must be recorded with a minimum of one measurement per second (1 Hz). 3.8.3. Particulate sampling (if applicable) At the start of the engine or test sequence, if the cycle is started directly from the preconditioning, the particulate sampling system must be switched from by-pass to collecting particulates. If no flow compensation is used, the sample pump(s) must be adjusted so that the flow rate through the particulate sample probe or transfer tube is maintained at a value within ± 5 per cent of the set flow rate.